Physics NCERT Exemplar Solutions Class 12th Chapter Six
Get insights from 87 questions on Physics NCERT Exemplar Solutions Class 12th Chapter Six, answered by students, alumni, and experts. You may also ask and answer any question you like about Physics NCERT Exemplar Solutions Class 12th Chapter Six
Follow Ask QuestionQuestions
Discussions
Active Users
Followers
New answer posted
4 months agoContributor-Level 10
This is a short answer type question as classified in NCERT Exemplar
When cylindrical bar magnet of radius 0.8 cm is dropped through the metallic pipe with an inner radius of 1 cm, flux linked with the cylinder changes and consequently eddy currents are produced in the metallic pipe. According to Lenz's law, these currents will oppose the (cause) motion of the magnet.
Therefore, magnet's downward acceleration will be less than the acceleration due to gravity g. On the other hand, an non magnetised iron bar will not produce eddy currents and will fall with an acceleration due to gravity g.
Thus, the magnet will take more time to come down
New answer posted
4 months agoContributor-Level 10
This is a short answer type question as classified in NCERT Exemplar
When the current is switched on, magnetic flux is linked through the ring. Thus, increase influx takes place. According to Lenz's law, this increase in flux will be opposed and it can happen if the ring moves away from the solenoid.
This happen because the flux increases will cause a counter clockwise current (as seen From the top in the ring in figure.) i.e., opposite direction to that in the solenoid. This makes the same sense of flow of current in the ring (when viewed from the bottom of the ring) and solenoid forming same magnetic pole in front of each other. Hence,
New answer posted
4 months agoContributor-Level 10
This is a short answer type question as classified in NCERT Exemplar
When the current is switched on, magnetic flux is linked through the ring. Thus, increase in flux takes place. According to Lenz's law, this increase in flux will be opposed and it can happen if the ring moves away from the solenoid.
This happen because the flux increases will cause a counter clockwise current (as seen from the top in the ring in figure.) i.e., opposite direction to that in the solenoid. This makes the same sense of flow of current in the ring (when viewed from the bottom of the ring) and solenoid forming same magnetic pole in front of each other. Hence
New answer posted
4 months agoContributor-Level 10
This is a short answer type question as classified in NCERT Exemplar
When the iron core is inserted in the current carrying solenoid, the magnetic field increase due to the magnetisation of iron core and consequently the flux increases.
According to Lenz's law, the emf produced must oppose this increase in flux, which can be done by making decrease in current. So, the current will decrease.
New answer posted
4 months agoContributor-Level 10
This is a short answer type question as classified in NCERT Exemplar
When the coil is stretched so that there are gaps between successive elements of the spiral coil i.e., the wires are pulled apart which lead to the flux leak through the gaps.
According to Lenz's law, the emf produced must oppose this decrease, which can be done by an increase in current. So, the current will increase.
New answer posted
4 months agoContributor-Level 10
This is a short answer type question as classified in NCERT Exemplar
When the switch is thrown from the off position (open circuit) to the on position (closed circuit), then neither B, nor A nor the angle between B and A change. Thus, no change in magnetic flux linked with coil occur, hence no electromotive force is produced and consequently no current will flow in the circuit.
New answer posted
4 months agoContributor-Level 10
This is a long answer type question as classified in NCERT Exemplar
New answer posted
4 months agoContributor-Level 10
This is a long answer type question as classified in NCERT Exemplar
According to faraday's law e= - and also ohm's law V=IR
So by equating these two
We get Bo( )
I=
And energy lost/second = I2R=
As change in PE=mg but if we compare both energy then
Mgv=
or v=
New answer posted
4 months agoContributor-Level 10
This is a long answer type question as classified in NCERT Exemplar
The conductor of length d moves with speed v, perpendicular to magnetic field B as shown in figure. This produces motional emf across two ends of rod, which is given by= vBd.
Since, switch S is closed at time t= 0. current start growing in inductor by the potential
Difference due to motional emf.
Applying Kirchhoff's voltage rule, we have
-L +vBd=IR
On solving differential equation we get I= + Ae-Rt/2
At t=0 I=0
A= -vBd/R
I= (1-e-Rt/L)
New answer posted
4 months agoContributor-Level 10
This is a long answer type question as classified in NCERT Exemplar
The conductor of length d moves with speed v, perpendicular to magnetic field B as shown in figure. This produces motional emf across two ends of rod, which is given by= vB d.
Since, switch S is closed at time t= 0. capacitor is charged by this potential difference. Let
Q ( t) is charge on the capacitor and current flows from A to B.
Now, the induced current I= -
On rearranging = + dQ/dt =
On solving differential equation we get I= e-t/RC
Taking an Exam? Selecting a College?
Get authentic answers from experts, students and alumni that you won't find anywhere else
Sign Up on ShikshaOn Shiksha, get access to
- 65k Colleges
- 1.2k Exams
- 687k Reviews
- 1800k Answers