Physics

This is a Long Answer Type Questions as classified in NCERT Exemplar

Explanation- refractive index = 1.38 refractive index = 1.5

^{$\lambda =5500A$ 0}

Consider a ray incident at an angle i. A part of this ray is reflected from the air-film interface And apart refracted inside.

This is partly reflected at the film-glass interface and a part transmitted. A part of the

reflected ray is reflected at the film-air interface and a part transmitted as r2 parallel to r 1. Of course successive reflections and transmissions will keep on decreasing the amplitude of the wave. Hence, rays r 1 and r2 shall dominate the behaviour. If incident light is to be transmitted through the lens, r 1 and r2 should interfere destructively. Both the reflections at A and D are from lower to higher refractive index and hence, there is no phase change on reflection. The optical path difference between r₂ and r₁ is

n(AD+CD)-AB

if d is the thickness of the film , then AD=CD=d/cosr

AB=AC sini

AC/2= d tanr

AC= 2dtanr

Hence AB= 2d tanr sini

Thus the optical path difference = $\frac{2nd}{cosr}$ -2dtanrsini

= 2. $\frac{sinid}{sinrcosr}$ - 2d $\frac{sinr}{cosr}sini$

= 2dsin{ $\frac{1-{sin}^{2}r}{sinrcosr}$ }

= 2ndcosr

For path difference $\frac{\lambda }{2}$

2ndcosr= $\frac{\lambda }{2}$

ndcosr= $\frac{\lambda }{4}$

for photographic lenses, the sources are normally in vertical plane

i=r=0⁰

ndcos0= $\frac{\lambda }{4}$

d= $\frac{\lambda }{4n}$ =5500/4 $*1.38$ = 1000A⁰

This is a Long Answer Type Questions as classified in NCERT Exemplar

Explanation-consider the disturbance at the receiver R₁ which is at a distance d from B

Y_A= acos(wt)  and path difference is $\frac{\lambda }{2}$  hence phase difference is $\pi$ .

Thus the wave R₁ because of B

Y_B= acos(wt- $\pi$ )= - acoswt here path difference is $\lambda$  and hence phase difference is $2\pi$

Thus R₁ because of C

Y_c= acos(wt-2 $\pi$ )= acoswt

(i)let the signal picked up at R₂ from B be Y_B= a₁cos(wt)

The path difference between signal at D and that B is $\frac{\lambda }{2}$

Y_D= -a₁cos(wt)

The path difference between signal at A and that atB is

$\sqrt[]{d^2+{\left(\frac{\lambda }{2}\right)}^2}$ -d = d( ${1+\frac{{\lambda }^2}{4D^2})}^{1/2}$ -d = $\frac{{\lambda }^2}{8d^2}$

$asd?\lambda$  therefore path difference os 0

$phasedifference=\frac{2\pi }{\gamma }\frac{{\lambda }^2}{8d^2}$

_{$Y$ A}=a₁cos(wt- $\varnothing$ )

_{$Y$ C}=a₁cos(wt- $\varnothing$ )

Therefore signal picked up by R₂ is

Y_A+Y_b+Y_c+Y_d= y = 2a₁cos(wt- $\varnothing$ )

|y|² = 4a₁²cos²(wt- $\varnothing$ )

=2a₁². Thus R₁ picks up the larger signal.

(ii) if B is swiched off

R₁ picks up y = acoswt

^{IR1= $\frac{1}{2}$ a2}

R₂ picks up  y = a coswt

I_R2= $\frac{1}{2}$ a²

(iii) thus R₁ and R₂ pick up the same signal

If D is switched off

R₁ picks up by y = acoswt

I_R1= $\frac{1}{2}$ a²

Y= 3acoswt

I_R2=9a²/2

R₂ picks up larger signal compared to R₁

(iv) thus a signal at R₁ indicates B has been switched off and an enhanced signal at R₂ indicates D has been switched off.